GLAST / LAT > DAQ and FSW > FSW > Doxygen Index> FES / V6-6-0 > fesxctl / rhel6-32
initrun | Initialize a run |
startrun | Start a run |
pause | Pause a run |
termrun | Terminate a run |
showrun | Show the status of a run |
ppswait | Wait until the next PPS signal has arrived |
logdisp | Display the contents of the message log file |
help | Show usage information about commands |
-A acd-path | ACD path (0 = primary, 1 = redundant) to use in run | initrun |
-a | Display data for all sides of each board shown | showrun |
-b | Display data for all boards in the system | showrun |
-C | Use external clock during run | startrun |
-c cfg-file | The configuration file name (if not default) | all |
-d dist-type | The event time distribution type (default 0) | initrun |
-E | Use external control to start run | startrun |
-f format | The format version number (default 0) | gen |
-g | Flag gamma events | initrun |
-i intvl | The interval (50 ns units) between events (default 20K) | initrun |
-m detc-mask | Use only boards with set bits in detc-mask | initrun |
-n | Generate event numbers | initrun |
-o oneshot | The trigger lines one-shot value (default 3) | initrun |
-P | Don't start run until the next PPS signal | startrun |
-p proc-cnt | The number of events or lines to process in the file | initrun, logdisp |
-R | Report end of run to external system | startrun |
-r rept-cnt | The number of times to repeat the file (default 0) | initrun |
-S | Respond to CALSTROBE signal; needed for calibration run | initrun |
-s skip-cnt | The number of events or lines to skip at the start of the file | initrun, logdisp |
-t | Display information on the remote server instead of locally | showrun |
-v | Display memory levels as values instead of percentages | showrun |
-x expn-fctr | The intra-event time expansion factor (default 0) | initrun |
file-stem | The name of the file stem to be used. This is the absolute path name (no node or disk name) with the file type omitted. | initrun |
command | The command name or its unique abbreviation. | help |
timeout | The optional timeout (seconds). Defaults to 1. | ppswait |
initrun [-ngS] [-c cfg-file] [-m detc-mask] [-i intvl] [-x expn-fctr] [-o one-shot] [-r rept-cnt] [-s skip-cnt] [-p proc-cnt] [-d dist-type] [-A acd-path] file-stem | |
Initializes a run using the set of data files specified by file-stem. The set of boards to be used may be restricted via the -m option; the other boards in the system generate null data. Other options specify various parameters of the run. | |
startrun [-ECRP] [-c cfg-file] | |
Starts a run that has been initialized or paused. | |
pauserun [-c cfg-file] | |
Pauses a run that has been started. | |
termrun [-c cfg-file] | |
Terminates a run. | |
showrun [-abtv] [-c cfg-file] | |
Shows the status of a run. | |
ppswait [-c cfg-file] [timeout] | |
Waits until the arrival of the next PPS signal. | |
logdisp [-c cfg-file] [-s skip] [-p proc] | |
Displays the contents of the message log file. If the skip value is negative, the display starts that number of lines from the end of the file, instead of the beginning. | |
help [command] | |
If command is specified, summarizes it. Otherwise gives a brief summary of all commands. |