# CONFIG_SITE

# Make any application-specific changes to the EPICS build
#   configuration variables in this file.
#
# Host/target specific settings can be specified in files named
#   CONFIG_SITE.$(EPICS_HOST_ARCH).Common
#   CONFIG_SITE.Common.$(T_A)
#   CONFIG_SITE.$(EPICS_HOST_ARCH).$(T_A)

# CHECK_RELEASE controls the consistency checking of the support
#   applications pointed to by the RELEASE* files.
# Normally CHECK_RELEASE should be set to YES.
# Set CHECK_RELEASE to NO to disable checking completely.
# Set CHECK_RELEASE to WARN to perform consistency checking but
#   continue building anyway if conflicts are found.
CHECK_RELEASE = YES

# Set this when you only want to compile this application
#   for a subset of the cross-compiled target architectures
#   that Base is built for.
#CROSS_COMPILER_TARGET_ARCHS = vxWorks-mpc8540 vxWorks-ppc604_long vxWorks-ppc604_altivec
#CROSS_COMPILER_TARGET_ARCHS = RTEMS-beatnik RTEMS-mvme3100 RTEMS-uC5282 linuxRT-x86

# If you only want to build for the host then uncomment the line below and no cross targets
# will be built.  Remember EPICS will build for the HOST ARCH by default.
#CROSS_COMPILER_TARGET_ARCHS =
CROSS_COMPILER_TARGET_ARCHS = RTEMS-beatnik RTEMS-mvme3100 RTEMS-uC5282 linuxRT-x86 linuxRT-x86_64 linuxRT_glibc-x86_64


# To install files into a location other than $(TOP) define
#   INSTALL_LOCATION here.
#INSTALL_LOCATION=</path/name/to/install/top>

# Set this when your IOC and the host use different paths
#   to access the application. This will be needed to boot
#   from a Microsoft FTP server or with some NFS mounts.
# You must rebuild in the iocBoot directory for this to
#   take effect.
#IOCS_APPL_TOP = </IOC/path/to/application/top>
IOCS_APPL_TOP  = $(INSTALL_LOCATION)

INSTALL_LOCATION_STARTUP += $(INSTALL_LOCATION)/startup
DIRECTORY_TARGETS += $(INSTALL_LOCATION_STARTUP)
