Update Dechiper logic per R Iverson: Remove LTU Dechirper - 10 Hz Rate Limit if Dechirper Not Out One again, this incarnation of this logic will be as special 'commissioning' mode, but once this is tested and approved, it will be a permanent change. [sonya@lcls-dev2 algorithm]$ sdiff -bs 2016-01-22-a/doc/MPSLogicDocumentation.txt 2016-01-22-b/doc/MPSLogicDocumentation.txt .. title:: MPS Logic 2016-01-22-a | .. title:: MPS Logic 2016-01-22-b LTU Dechirper - 10 Hz Rate Limit if Dechirper Not Out < ----------------------------------------------------- < The following code assigns the truth table's state number to < < /* < * This logic enforces a 10 Hz rate unless < * < * a. All 4 Dechirper jaws are OUT < * or < * b. An upstream stopper (YAG01, YAG02, TD11, D2) is IN < * < * It's a little unusual because inputs are not used in < * and there is only one state in the truth table. < * < * If you need to bypass this, you must manually bypass t < * jaw(s) that are not out to IS_OUT < * < * These inputs are in Link Node 28, Card 2: < * < * Ch 1 DCHP:LTU1:555:OUT_LIMSW_NEGX < * Ch 2 DCHP:LTU1:555:OUT_LIMSW_POSX < * Ch 3 DCHP:LTU1:545:OUT_LIMSW_NEGY < * Ch 4 DCHP:LTU1:545:OUT_LIMSW_POSY < */ < < state = 1; < ================== ===== ==================== =============== < Name State Pockels Cell Mechanical Shu < ================== ===== ==================== =============== < Dechirpers Not Out 1 10 Hz < ================== ===== ==================== =============== < < <