Date: Wed, 1 Oct 2014 18:37:51 +0000 From: "Smith, Tonee J." To: "Hoobler, Sonya" , "Turner, James L." Cc: "Alverson, Shawn Christopher" Subject: RE: New MPS logic to prevent soft x-rays from entering hard x-ray line Hi Sonya, I think that would be fine until we get a limit switch on the IN position. In the meanwhile I can have the guardian cover the {M1S Not on the OUT limit && M1S position not in the IN position range} case, if Jim wishes. Cheers, -Tonee ________________________________________ From: Sonya Hoobler Sent: Wednesday, October 1, 2014 9:22 AM To: Turner, James L.; Smith, Tonee J. Cc: Alverson, Shawn Christopher Subject: New MPS logic to prevent soft x-rays from entering hard x-ray line Hello, Jim asked that we add logic to the MPS that will prevent soft x-rays from entering the hard x-ray line. We need a IN limit switch on M1S and another digital input for the energy to do this properly. But we can put in temporary logic for now: If the e- beam energy is < 6.75 GeV AND M1S is OUT, cause an MPS fault. Keep in mind this logic is not fail-safe (because we are using negative logic) and does not cover the case in which M1S is moving or stuck between IN and OUT. Tonee, Jim, would you please review this and get back to me? Jim, do you still think there will be an opportunity to release this this week? How about this afternoon? Thanks, Sonya .. title:: MPS Logic 2014-09-24-a | .. title:: MPS Logic 2014-10-01-a > Ignored when Spoiler SP0 Is In, ST1/ST2 Are In, Stopper: BSY > ============================================================= > > HXR - Beam Energy Too Low With M1S Out > -------------------------------------- > ===== = = ==================== ==================== ========= > Name B A Pockels Cell Mechanical Shutter BY > ===== = = ==================== ==================== ========= > Ok F F 120 Hz 120 Hz > Ok F T 120 Hz 120 Hz > Ok T F 120 Hz 120 Hz > Fault T T 0 Hz 0 Hz > ===== = = ==================== ==================== ========= > > Where:: > > A = MIRR_FEE1_1560_ENERGY_STATE > B = MIRR_FEE1_1560_OUT_LIMIT1_POSITION > > >