Update Dechiper logic per R Iverson: Remove LTU Dechirper - 10 Hz Rate Limit if Dechirper Not Out First incarnation of this logic will be as special 'commissioning' mode, but once this is tested and approved, this will likely be the next release of logic. [sonya@lcls-dev2 algorithm]$ sdiff -bs 2015-10-10-b/doc/MPSLogicDocumentation.txt 2015-10-10-a/doc/MPSLogicDocumentation.txt .. title:: MPS Logic 2015-10-10-b | .. title:: MPS Logic 2015-10-10-a > LTU Dechirper - 10 Hz Rate Limit if Dechirper Not Out > ----------------------------------------------------- > The following code assigns the truth table's state number to > > /* > * This logic enforces a 10 Hz rate unless > * > * a. All 4 Dechirper jaws are OUT > * or > * b. An upstream stopper (YAG01, YAG02, TD11, D2) is IN > * > * It's a little unusual because inputs are not used in > * and there is only one state in the truth table. > * > * If you need to bypass this, you must manually bypass t > * jaw(s) that are not out to IS_OUT > * > * These inputs are in Link Node 28, Card 2: > * > * Ch 1 DCHP:LTU1:555:OUT_LIMSW_NEGX > * Ch 2 DCHP:LTU1:555:OUT_LIMSW_POSX > * Ch 3 DCHP:LTU1:545:OUT_LIMSW_NEGY > * Ch 4 DCHP:LTU1:545:OUT_LIMSW_POSY > */ > > state = 1; > ================== ===== ==================== =============== > Name State Pockels Cell Mechanical Shu > ================== ===== ==================== =============== > Dechirpers Not Out 1 10 Hz > ================== ===== ==================== =============== > >