We get PPYY from PNET We use LLRF, Injector, and RF triggers independently We support On demand 10 Hz 30 Hz 60 Hz 120 Hz Dithering - make triggers be 2 up and 2 down but they could be at 10 Hz or 120 Hz these things can be programmed --- user defined bits that support rate, number up, number down. Dithering may not occur at slower rates - so it needs to be specified can use EVG defined commands BUT the MPG needs to know when we rate limit (Linda) Does the MPG need to know when the BPM was no good - This is the MPS information (Tony) Slice emittance application Want to turn on and off from UNIX Gnerate a single shot measurement on one pulse in which I cause an image to be captured along with some number of BPMs Trigger at a programmed rate - independent for controllers Trigger some diagnostics at some rate (RF deflecting cavity, beam dumper, something else) (These may run at 1 or 10 Hz) (pulsed kicker over to the profile monitor) (and coordinate the camera) (This may also need to tell portions of MPS about this) (fast feedback would also need to know about this) one trigger should be enable feedback - (for each loop? or for all loops?) there will be multiple beams with multple triggers will eventually need to support many beamlines