Running the Simulation



next up previous contents
Next: Restarting or Repeating Up: Simulation of a Previous: Beam Configuration Overlay

Running the Simulation

With the AP and algorithm selected and the devices and beam settings configured as desired, you can then prepare to run a simulation by returning to the MPSAS main panel. Through the toggling of the ``display'' and ``file output'' buttons, you can choose between having the output displayed in the output window, written to a file of your choice, or both. If you select to have the output written to a file, be sure to use the file selection windows and buttons on the right half of the MPSAS main panel.

Finally (yes, finally) the simulation can then be executed by pressing the cleverly named ``RUN'' button. The output produced will appear in the following format:

The results will be output in this format for each combination of beam group and rate-limiting kind that has been set active in the configuration process.



SLAC Controls Software
Fri Nov 4 11:56:07 PST 1994