|
Overview
The following directions are for installing NetObjects Fusion MX. However, since version 7 of NetObjects is being released soon and we will probably be using that version in the future, this page will be updated soon to reflect any changes in installation procedure.
Installing NetObjects Fusion MX
- Acquire an installation CD-ROM from Tom Knight.
- Insert the CD-ROM into your drive and wait for the installation screen to appear. If it doesn’t, double-click on the CD icon in “My Computer.”
- In the menu screen, select “Launch Installer.”
- Click “Next” on the next two dialogues and “Yes” on the agreement form.
- On the serial number enter page, leave (or enter if necessary) the Name and Company both as SLAC. Enter the serial number, found on a sticker on the CD cover, and then click “Next.” Confirm the information on the next dialogue by click “Yes.”
- Allow the program to install at C:\NetObjects Fusion MX, and click “Next”
- Select “Typical” as the installation type and click “Next”
- NetObjects should not have been installed on the computer, so click “No” for the next question.
- Allow the installation to proceed, and reboot when prompted.
- After rebooting, go to the NetObjects site. Go to their Support page and download the NetObjects Fusion MX Updater version 6.20. The exact page is here.
|
