Machine Protection System
New MPS
Some references:
-
New MPS Micro FAQ
-
Index Panel Article Vol. 7, No. 7 11 November 1993
- Smart Machine Protection System, S. Clark et al., November 1991,
SLAC-PUB-5688
- MPS Beam Control Software Architecture, K. Krauter and M. Crane, April 1993
SLAC-PUB-6149
- MPS VAX Monitor and Control Software Architecture, S. Allison et al., April 1993,
SLAC-PUB-6155
- AMS: Area Message Service for SLC, M. Crane et al., April 1993,
SLAC-PUB-6166
-
More than you ever wanted to know about MPS Algorithms, Howard Smith
- The New MPS SCP panels also have a lot of help.
- New MPS schematic drawing
Architecture
- Draw system schematic including the following components
- Devices
- MCC Alpha
- MPG
- SP00
- MPG/SP00 shared memory card
- APs
- SLC Micros
- SLC CAMAC crates
- MPS CAMAC modules
- MPS Beamline device
- MPS Watchdog
- SCP
- Cabling
- SLCNet
- Fiber optic
- Milport 1553
- 10BaseT Ethernet
- CAMAC crate bus
- In two or three sentences, describe the role of each of the above devices.
- Describe how the following software is used by the New MPS
- AP algorithm
- SP00 algorithm
- CAMAC MPS module configuration
- MCC Alpha processes
- MPS controller
- AP event managers
- MPS permits
- Supervisor beam permit
- VAX beam permit
- Deadman beam permit
- General
- Explain how beam loss near an MPS ion chamber results in a beam rate change (trace
signal and describe logic in devices along the path).
- 50B1 is an MPS stopper. What is an MPS stopper?
TIU-Based MPS
- General
- When in BAS-II Mode:
- which sector(s) is/are bypassed in the TIU system?
- which other TIU inputs are bypassed?
- How does a TIU fault interrupt beam?
- When are the Linac slow valves automatically inserted? The fast valves?
- Why are VVS and subbooster statuses TIU inputs? How do they differ from other inputs?
Device/Area Specific MPS
Maintained by
Sonya Hoobler
Last modified: October 2006