Abstracts |
R.D. Demaret, E.S. Bliss, R.D. Boyd, A.J. Gates, J.R. Severyn
The National Ignition Facility laser focuses 1.8 Mega-joules of ultraviolet light (wavelength 351 nano-meters) from 192 beams into a 600-micro-meter-diameter volume. Effective use of this output in target experiments requires that the power output from all the beams match within 8% over their entire 20-nanosecond waveform. The scope of NIF beam diagnostics systems necessary to accomplish this task is unprecedented for laser facilities. Each beam line contains 110 major optical components distributed over a 510 meter path, and diagnostic tolerances for beam measurement are demanding[1]. Total laser pulse energy is measured with 2.8% precision, and the inter-beam temporal variation of pulse power is measured with 4% precision. These measurement goals are achieved through use of approximately 160 sensor packages that measure the energy at five locations and power at 3 locations along each beamline using 335 photodiodes, 215 calorimeters and 36 digitizers. Successful operation of such a system requires a high level of automation of the widely distributed sensors. Computer control systems provide the basis for operating the shot diagnostics with repeatable accuracy, assisted by operators who oversee system activities and setup, respond to performance exceptions, and complete calibration and maintenance tasks.
[1] E.S. Bliss et al.,'Design Progress for the National Ignition Facility Laser Alignment and Beam Diagnostics,'
{*} This work was performed under the auspices of the U.S. Department of Energy by University of California Lawrence Livermore National Laboratory under contract No. W-7405-Eng-48.
eCONF
C011127
ePROCEEDINGS
COMMITTEES
PARTICIPANTS
PROGRAM
SUMMARY
ICALEPCS 2001
eCONF
|
||
Last updated: September 13, 2002 Website Problem? Contact Technical Publications |