gdb.info: Analyze Collected Data

Go forward to Tracepoint Variables
Go backward to Set Tracepoints
Go up to Tracepoints
Go to the top op gdb

Using the collected data

After the tracepoint experiment ends, you use GDB commands for
examining the trace data.  The basic idea is that each tracepoint
collects a trace "snapshot" every time it is hit and another snapshot
every time it single-steps.  All these snapshots are consecutively
numbered from zero and go into a buffer, and you can examine them
later.  The way you examine them is to "focus" on a specific trace
snapshot.  When the remote stub is focused on a trace snapshot, it will
respond to all GDB requests for memory and registers by reading from
the buffer which belongs to that snapshot, rather than from _real_
memory or registers of the program being debugged.  This means that
*all* GDB commands (`print', `info registers', `backtrace', etc.) will
behave as if we were currently debugging the program state as it was
when the tracepoint occurred.  Any requests for data that are not in
the buffer will fail.