gdb.info: A29K

Go forward to Alpha
Go up to Architectures
Go to the top op gdb

A29K

`set rstack_high_address ADDRESS'
     On AMD 29000 family processors, registers are saved in a separate
     "register stack".  There is no way for GDB to determine the extent
     of this stack.  Normally, GDB just assumes that the stack is
     "large enough".  This may result in GDB referencing memory
     locations that do not exist.  If necessary, you can get around
     this problem by specifying the ending address of the register
     stack with the `set rstack_high_address' command.  The argument
     should be an address, which you probably want to precede with `0x'
     to specify in hexadecimal.
`show rstack_high_address'
     Display the current limit of the register stack, on AMD 29000
     family processors.