annotate.info: Breakpoint Info

Go forward to Invalidation
Go backward to Errors
Go up to Top
Go to the top op annotate

Information on Breakpoints

_Breakpoint Annotations have been removed.  GDB/MI instead provides
breakpoint commands._
   The output from the `info breakpoints' command is annotated as
follows:
     ^Z^Zbreakpoints-headers
     HEADER-ENTRY
     ^Z^Zbreakpoints-table
where HEADER-ENTRY has the same syntax as an entry (see below) but
instead of containing data, it contains strings which are intended to
convey the meaning of each field to the user.  This is followed by any
number of entries.  If a field does not apply for this entry, it is
omitted.  Fields may contain trailing whitespace.  Each entry consists
of:
     ^Z^Zrecord
     ^Z^Zfield 0
     NUMBER
     ^Z^Zfield 1
     TYPE
     ^Z^Zfield 2
     DISPOSITION
     ^Z^Zfield 3
     ENABLE
     ^Z^Zfield 4
     ADDRESS
     ^Z^Zfield 5
     WHAT
     ^Z^Zfield 6
     FRAME
     ^Z^Zfield 7
     CONDITION
     ^Z^Zfield 8
     IGNORE-COUNT
     ^Z^Zfield 9
     COMMANDS
   Note that ADDRESS is intended for user consumption--the syntax
varies depending on the language.
   The output ends with
     ^Z^Zbreakpoints-table-end