|
|
Input Commands
Commands for Framework interface with the standard input module: (Issued
during talk session with the active input module.)
in[put] add [-[no]v[alidate]] [-[no]c[heck]] <file1>
[<file2> ...]
- The input add
command adds the specified
file(s) to the end of the input file list. By default the specified
file(s) is immediately validated to check that they exist and are
readable by the application. This check may be bypassed for some of
the files by use of the -novalidate or -nocheck switches. The checks
may be re-established with the -validate or -check switches.
in[put] file [-[no]v[alidate]] [-[no]c[heck]] [<mod3>]
<file2> [ <file2> ...]
- The input file command is synonymous with the
input add command.
in[put] list
- The input list command lists the current input
file.
in[put] nosilent
- The input nosilent command sets the framework
into a mode where the opening and closing of each input file will be echoed
on the standard output during the course of the event processing loop controlled
by the events command. This is the default.
in[put] remove <file1> [<file2>
...]
- The input remove command removes the specified
file or files from the input file list.
in[put] silent
- The input silent command sets the framework into
a mode where the opening and closing of each input file is not echoed to
standard output.
in[put] wipe[-out]
- The input wipe[-out] command clears the input
file list.
Return to Framework page
Last edited by:Jenny Williams
Last modification: 12 February 2003
Last significant update: ?1999
|
|
